Following on from theĀ NEC Single Screen Setup Procedure


These steps detail what needs to be done to get RS232 and Displayport loop-though working across all the screens connected.


Cabling

To get Display port to work across all the screens, there is a special requirement to get all of them working together.

The screens require to be looped through from LCD 1's port 1 to LCD 2's port 2 etc.


To do this you:

Loop the 'out' into the 'in' of the next screen in order.


To set up the RS232 you need to:

Loop the 'out' from the first screen, into the 'in' of the second screen etc.


It should be looped as follows:




When this is done make sure to set the IP address to AUTO on the screen via the menu


And then set AUTO ID to YES